-
Q When the hydraulic system has unstable pressure or the slide table is crawling, which components should be checked first?
A It is recommended to first check the hydraulic oil level and whether the oil temperature is too high, then check the working status of the hydraulic pump and the overflow valve, and confirm whether there is internal leakage in the balance cylinder. Regularly replacing the hydraulic oil and filter element can effectively avoid such problems.
-
Q Will the single-edge shearing of the cutting unit cause deformation at the end of the angle steel? What is the maximum shearing thickness?
A The single-edge shearing design ensures a neat cutting surface and no waste. Under normal operating conditions, there will be no obvious deformation. Please refer to the equipment parameter table for the specific maximum shearing thickness (usually related to the angle steel specification), and replace the filter element regularly within the recommended range to ensure the quality of the cut.
-
Q What medium does the micro mist cooling lubrication system need to be added regularly? What is the maintenance cycle?
A The system uses a special micro mist cooling lubricating fluid. It is recommended to check the fluid level and whether the nozzles are clogged once every 200 hours of operation, and replace the filter element regularly according to the usage frequency to ensure the cooling and lubrication effect.
-
Q How many different diameters of drill bits can be installed in the drilling unit? Is it convenient to replace the drill bits?
A Each drilling unit can accommodate three drill bits of different diameters. The drill bits are made of hard alloy material. Replacement requires stopping the operation. It is recommended to follow the standard procedures to ensure the accuracy of the spindle and the lifespan of the cutting tools.
