A

A The automatic feeding mechanism (clamping trolley) is controlled by servo motors and encoders in a closed loop. The operator inputs the length and quantity of each section on the touch screen, and the equipment will automatically feed, clamp, saw, and then feed again until all batches are completed. It supports storing multiple workpiece recipes for convenient repeated use. The first piece is recommended to be verified using the "single-step execution" mode for the length.

A The laser alignment light can be independently switched through the operation panel. When using it, first place the workpiece close to the positioning stop block, then turn on the laser light, and move the rollers to fine-tune them to align the laser line with the sawing marking line on the workpiece. It is recommended to use it in a dimly lit environment and clean the laser head lens regularly to prevent offset caused by iron filings blocking.

A The equipment adopts a unique design. When the resistance increases, the saw frame will automatically execute the "lift/lower" reciprocating sawing mode, allowing the saw blade to temporarily separate from the workpiece and then slowly enter, thereby significantly reducing the phenomenon of clamping the saw. If this action occurs frequently, it indicates that the feed speed is too fast or the saw blade is worn, and the parameters should be appropriately reduced or the saw blade replaced.

A The equipment will automatically adjust the feed speed according to the change in the sawing cross-sectional size, without the need for manual intervention. The system adjusts in real time by detecting the sawing resistance or preset parameters to ensure sawing efficiency and the lifespan of the saw blade. It is recommended to observe the sawing sound and current during the first piece processing, and if abnormal vibration is detected, manually fine-tune the upper limit speed.